TA Triumph-Adler 2256 - Manual (Page 25)

1-11
Setting up the Machine > Local FAX Information Entry
ECM TX
Set whether ECM TX is performed. ECM is a communication mode specified by the ITU-T (International
Telecommunication Union) that retransmits data when an error occurs. Fax machines that have ECM mode check for
errors as they communicate, preventing distortion of the image due to noise on the line and other conditions.
1
Display the screen.
1 Press the [ Status/System Menu/Counter ] key.
2 Press the [ ▲ ] or [ ▼ ] key to select [FAX].
3 Press the [ OK ] key.
4 Press the [ ▲ ] or [ ▼ ] key to select [Transmission].
5 Press the [ OK ] key.
6 Press the [ ▲ ] or [ ▼ ] key to select [ECM TX].
7 Press the [ OK ] key.
2
Configure the settings.
1 Press [ ▲ ] or [ ▼ ] to select [On] or [Off].
2 Press the [ OK ] key.
TX Start Speed
Set the TX Start Speed. When communication conditions are bad, the fax may not be transmitted correctly. In that case,
set a lower TX Start Speed.
1
Display the screen.
1 Press the [ Status/System Menu/Counter ] key.
2 Press the [ ▲ ] or [ ▼ ] key to select [FAX].
3 Press the [ OK ] key.
4 Press the [ ▲ ] or [ ▼ ] key to select [Transmission].
NOTE
When there is a large amount of noise on the line, communication may take slightly longer
than when [Off] is selected.
NOTE
Normally this should be used with the default setting.