TA Triumph-Adler 2256 - Manual (Page 41)

3-2
Sending Faxes > Basic transmission procedure
Basic transmission procedure
The basic procedure for using the fax system is explained below.
1
Press the [ FAX ] key.
The base screen for fax appears.
2
Place the originals.
Refer to the machine’s Operation Guide for placing originals.
3
Select the transmission method.
There are two transmission methods: memory transmission and direct transmission.
Memory transmission: The original is scanned into memory before communication starts.
Memory transmission is selected by default.
Direct transmission: The destination is dialed and communication starts before the original is
scanned.
For details, refer to FAX Direct Transmission on page 3-17 .
4
Specifying destination.
Enter the fax number of the receiving system using the numeric keys.
For the procedure for selecting a destination in the address book, refer to Choosing from the
Address Book on page 3-10 .
For the procedure for selecting the destination using the One Touch Key, refer to Choosing by One
Touch Key on page 3-12 .
NOTE
Up to 64 digits can be entered as the fax number of the receiving system.
Pressing the [ Address Recall/Pause ] key adds about three seconds of waiting time during
dialing. For example, when dialing the receiving system on an external line, you can use this
method to insert a pause before resuming dialing after you dial a specific number.
Ready to send.
2013/08/08 10:10
Resltion Duplex
200x200 Off
FAX No. Entry:
Chain Detail
0123456789