Precision Digital PD6310 - Manual (Page 97)

Model PD6210 & PD6310 Batch Controllers Instruction Manual
97
Display Parameter Action/Setting Description
mAx Maximum Program maximum mA output allowed
mbus Modbus Select to display Modbus input or to assign
Modbus input as the analog output source
menu Menu button Assign digital input to Menu button
min Minimum Program minimum mA output allowed
No PtS Number of points Set controller for 2 to 32-point linearization
nonrst Non-resettable Non-resettable grand total set after entering
“050873” for Gtotal password
O Hold Relays output
hold Assign digital input to hold all relays state
OFF Off Disable relay and front panel status LED,
turn relays off, program off time delay
OFF 1 Off Set relay 1 Off time delay
On On Enable fail-safe operation, turn relays on,
program on time delay
On 1 On Set relay 1 On time delay
O-rang Overrange Program mA output for display overrange
Out 1 Output 1 Program output 1 value (e.g. 4.000 mA)
Out 2 Output 2 Program output 2 value (e.g. 20.000 mA)
pass Password Enter the Password menu
Pass 1 Password 1 Set or enter Password 1
Pass 2 Password 2 Set or enter Password 2
Pass 3 Password 3 Set or enter Password 3
preCls Preclose The amount before the preset is reached
that multi-stage relays will deactivate.
preset Preset Batch control preset
prog Program Enter the Program menu
Prog E Programmable
exponent Set controller for programmable exponent
and enter exponent value
rATE Rate Assign relay to rate