Precision Digital PD6310 - Manual (Page 18)

Model PD6210 & PD6310 Batch Controllers Instruction Manual
18
INSTALLATION
There is no need to remove the controller from its case to com-
plete the installation, wiring, and setup of the controller for most
applications. Instructions are provided for setting up a
12/24 VDC powered controller to operate from 12 VDC and for
changing the transmitter power supply to output 5 or 10 VDC
instead of 24 VDC, see page 20.
Unpacking
Remove the controller from box. Inspect the packaging and
contents for damage. Report damages, if any, to the carrier.
If any part is missing or the controller malfunctions, please con-
tact your supplier or the factory for assistance.
Panel Mounting Instructions
 Prepare a standard 1/8 DIN panel cutout – 3.622" x 1.772" (92 mm x
45 mm). Refer to Figure 1 for more details.
 Clearance: allow at least 6.0" (152 mm) behind the panel for wiring.
 Panel thickness: 0.04" - 0.25" (1.0 mm - 6.4 mm).
Recommended minimum panel thickness to maintain Type 4X
rating: 0.06" (1.5 mm) steel panel, 0.16" (4.1 mm) plastic panel.
 Remove the two mounting brackets provided with the controller (back-off the
two screws so that there is ¼" (6.4 mm) or less through the bracket. Slide the
bracket toward the front of the case and remove).
 Insert controller into the panel cutout.

Install mounting brackets and tighten the screws against the panel. To
achieve a proper seal, tighten the mounting bracket screws evenly until con-
troller is snug to the panel along its short side. DO NOT OVER TIGHTEN, as
the rear of the panel may be damaged.
Note: See Figure 23 on page 101 for Error! Reference source not found.
3.622" (92mm)
1.772"
(45mm)
Panel Cutout
to DIN 43700
Square Corners to 0.060"
(1.5mm) Max Radius
A
B
Tolerances:
A: +0.032 (+0.8mm)
-0.000 (-0.0mm)
B: +0.024 (+0.6mm)
-0.000 (-0.0mm)
Panel
Gasket
Mounting
Bracket
Mounting
Screw
Removable
Connectors
Figure 1: 1/8 DIN Panel Cutout and Mounting