Precision Digital PD6310 - Manual (Page 31)

Model PD6210 & PD6310 Batch Controllers Instruction Manual
31
BASIC OPERATION AND PROGRAMMING
The PD6210 is factory calibrated prior to shipment to read in mil-
liamps and volts depending on the input selection. The calibration
equipment is certified to NIST standards.
The PD6310 has been factory calibrated to read input frequency
in Hz (pulses/sec). The calibration equipment is certified to NIST
standards.
Overview
There are no jumpers on the PD6210 to set for the controller input selec-
tion. There are two switches on the PD6310, located to the right of the
input connector, which must be configured according to the input level
and type. Jumper J4 located inside the controller, behind the input signal
connector, is used to select the excitation voltage (24 V*, 10 V or 5 V)
which is supplied to the P+ and P- wiring terminals.
Setup and programming is done through the front panel buttons.
After power and input signal connections have been completed and veri-
fied, apply power to the controller.
*Default Setting