Precision Digital PD6310 - Manual (Page 9)

Model PD6210 & PD6310 Batch Controllers Instruction Manual
9
SPECIFICATIONS
Except where noted all specifications apply to operation at +25°C.
General
DISPLAY Main display: 0.6" (15 mm) high, red LEDs
Second display: 0.46" (12 mm) high, red LEDs
6 digits: each (-99999 to 999999), with lead zero blanking.
DEFAULT
DISPLAY
ASSIGNMENT The main (Big) display shows batch total. The small (Little)
display shows rate with alternating units, and can be
switched to show grand total, batch count, or preset with
the STOP key.
CUSTOM
DISPLAY
ASSIGNMENT The main (Big) and small (Little) displays may be assigned
to rate, total, grand total, batch count, preset, set points,
units (lower display only), alternating R & T, R & GT, preset
& rate, max & min, or a Modbus display register. Any rate
display may be programmed to alternate with a custom unit
or tag.
ALTERNATING
DISPLAY Displays alternate every 10 seconds when display is se-
lected or the batch is paused.
DISPLAY
INTENSITY Eight user selectable intensity levels
DISPLAY
UPDATE RATE 5/second (200 ms)
OVERRANGE Display flashes 999999
UNDERRANGE Display flashes -99999
FRONT PANEL NEMA 4X, IP65
PROGRAMMING
METHODS Four front panel buttons, digital inputs, PC and MeterView
Pro software, or cloning using Copy function.
NOISE FILTER Programmable from 2 to 199 (0 will disable filter)
FILTER BYPASS Programmable from 0.1 to 99.9% of calibrated span
RECALIBRATION All ranges are calibrated at the factory. Recalibration is
recommended at least every 12 months.
MAX/MIN
DISPLAY Max/min readings reached by the process are stored until
reset by the user or until power to the controller is turned
off.