Precision Digital PD6310 - Manual (Page 38)

Model PD6210 & PD6310 Batch Controllers Instruction Manual
38
Display Parameter Action/Setting Description
Dis 1 Display 1 Program display 1 value
Inp 2 Input 2 Calibrate input 2 signal or program input 2
value (up to 32 points)
Dis 2 Display 2 Program display 2 value (up to 32 points)
Error Error Error, calibration not successful, check
signal or programmed value
T tb Total time
base Enter totalizer time base for seconds, mi-
nutes, hours or day.
T Cf Total conver-
sion factor Enter the conversion factor decimal point
and the conversion factor.
mode Batch mode Automatic or manual batch control
T dly Time delay Set time delay for automatic batch restart
GT tb Grand total
time base Program grand total time base
GT CF Grand total
conversion
factor Program grand total conversion factor
GT rst Grand total
reset Program grand total reset mode: auto or
manual
dsplay Display Enter the Display menu
big Big display Press Enter to assign the Main display
parameter (default: PV or rate)
Little Little display Press Enter to assign the small display
parameter (default: total)
d-Inty Display
intensity Set display intensity level from 1 to 8
RELaY Relay Enter the Relay menu
Assign Assignment Assign relays to rate, total (batch control),
grand total, or Modbus controlled. Relays
set to total function as batch control re-
lays.
Asign1 Assign 1 Relay 1 assignment
precls Batch total
relay preclose For relays beyond the first assigned to
total, a preclose amount may be entered
for that relay.
RLY 1 Relay 1 Relay 1 setup