Precision Digital PD6310 - Manual (Page 94)

Model PD6210 & PD6310 Batch Controllers Instruction Manual
94
Display Parameter Action/Setting Description
C CAL Current
calibration Calibrating 4-20 mA current input (internal
reference source used for scaling the input)
C Hi Current high Calibrate high current input (e.g. 20 mA)
C lo Current low Calibrate low current input (e.g. 4 mA)
C Tare Capture tare Capture tare
Cal Calibrate Enter the Calibrate menu
Calib Calibrate Calibrate 4-20 mA output (internal refer-
ence source used for scaling the output)
Contrl Control Enter Control menu
Copy Copy Enter copy function
Cutoff Cutoff Cutoff value
D Hi Display high Select to display the max
D HL Display H&L Select to display the max & min toggling
D Hold Display hold Display hold
D Lo Display low Select to display the min
D off Display off Select to not turn off display
D rate Display rate Select to display rate
D tot Display total Select to display batch total
D gtot Display grand
total Select to display grand total
D g-t Display g-t Select to display grand total and batch total
D r-t Display r-t Select to display rate and batch total
D r_u Display r-u Select to display rate and units
D unit Display units Select to display engineering units or label
dCount
Dec pt Decimal point Set decimal point for rate, total, grand total
DeLAY Delay Enter relay Time Delay menu
dI 1 Digital input 1 Assign digital input 1-8, if expansion mod-
ules are connected