Yaskawa Sigma-5 Large Capacity Users Manual: Design and Maintenance-Rotary Motors-Mechatrolink-III Communication Reference - Manual (Page 34)

1 Outline
1-12
1.6 Examples of Servo System Configurations
A system configuration for a three-phase main circuit power supply voltage of 400 VAC is shown in the fol-
lowing figure.
∗1. Use a 24-VDC power supply with double insulation or reinforced insulation. (The power supply is not included)
∗2. The DC power supply for the 24-VDC brake is not included.
• For 200-V input voltage: LPSE-2H01-E
• For 100-V input voltage: LPDE-1H01-E
Use one of the following power supplies for 90-VDC brake. For details, contact your Yaskawa representative or the
sales department. For details, refer to Large-Capacity
Σ -V series Catalog (Manual no.: KAEP S800000 86).
∗3. For details on grounding, refer to 3.10 Noise Control and Measures for Harmonic Suppression.
∗4. Before connecting an external regenerative resistor unit, refer to 3.8 Selecting and Connecting a Regenerative Resis-
tor Unit.
∗5. For details on the dynamic brake unit, refer to 3.9 Selecting and Connecting a Dynamic Brake Unit.
M-III
DV
R S T
DU DW
DBON
DB24
*3
*3
Power supply
Three-phase, 400 VAC
Converter SERVOPACK
Dynamic
brake unit
*5
SGMVV Servomotor
Motor main circuit cable
Motor fan cable
Encoder cable
Battery case
(when an absolute
encoder is used.)
When not using the
safety function, use
the SERVOPACK
with the safety function
jumper connector
inserted.
When using the safety
function, insert a
connection cable
specifically for the
safety function.
Safety function
devices
Thermostat cable
Magnetic
contactor
Turns the servo
ON and OFF.
Install a surge
absorber.
DC power
supply
(24 V)
*1
Brake power
supply
*2
Used for a
servomotor
with a 90 V brake.
Turns the brake power
supply ON and OFF.
Install a surge absorber.
100/200 VAC
Regenerative resistor *4
Molded-case circuit breaker
(MCCB)
Protects the motor fan by shutting
the circuit OFF when overcurrent
is detected.
Molded-case
circuit breaker
(MCCB)
Protects the power supply
line by shutting the
circuit OFF when
overcurrent is
detected.
Noise filter
Used to eliminate
external noise from
the power line.
Magnetic
contactor
Connect to the
MECHATROLINK-
III
Digital
operator
Personal
computer
Connection cable
for digital operator
Connection cable
for personal computer
I/O signal cable
Host controller