Yaskawa R1000 Series Power Regenerative Unit - Manual (Page 45)

3.5 Terminal Cover
YASKAWA ELECTRIC TOEP C710656 08B YASKAWA Power Regenerative Unit - R1000 Instruction Manual 45
El
ec
tr
ical
I
n
st
al
lat
ion
3
3.5 Terminal Cover
Follow the procedure below to remove the terminal cover for wiring and to reattach the terminal cover after wiring is
complete.
◆ Models 2A03P5 to 2A0028, 4A03P5 to 4A0028 (IP20/NEMA Type 1)
■ Removing the Terminal Cover
Loosen the terminal cover screw using a #2 Phillips screwdriver. Screw sizes vary by regenerative unit model.
Then, push in on the tab located on the bottom of the terminal cover and gently pull forward to remove the terminal cover.
Figure 3.12
Figure 3.12 Removing the Terminal Cover on an IP20/NEMA Type 1 Enclosure Model
■ Reattaching the Terminal Cover
Power lines and signal wiring should pass through the opening provided. Refer to Wiring the Main Circuit Terminal on
page 56 and Wiring the Control Circuit Terminal on page 61 for details on wiring.
Reattach the terminal cover after completing the wiring to the regenerative unit and other devices.
Figure 3.13 Reattaching the Terminal Cover on an IP20/NEMA Type 1 Enclosure Model
<1> Connect ground wiring first, followed by the main circuit, and then wire the control circuit. Power lines and signal wiring
exit through the opening provided.
YAI
<1>
YAI
TOEP_C710656_08B_1_0.book 45 ページ ２０１５年２月５日 木曜日 午前１０時７分