Yaskawa R1000 Series Power Regenerative Unit - Manual (Page 101)

5.3 Fault Detection
YASKAWA ELECTRIC TOEP C710656 08B YASKAWA Power Regenerative Unit - R1000 Instruction Manual 101
Tr
ou
blesh
oot
ing
5
Digital Operator
Display
Fault Name Details
Uv3
Undervoltage 3
(Soft-Charge Bypass
Circuit Fault)
The soft-charge bypass circuit failed.
Cause Possible Solution
The relay or contactor on the soft-charge
bypass circuit is damaged.
• Cycle power to the regenerative unit and see if the fault reoccurs.
• If the problem continues, replace either the control board or the entire regenerative unit. For
instructions on replacing the control board, contact Yaskawa or a Yaskawa representative.
• Check monitor U4-06 for the performance life of the soft-charge bypass.
• Replace either the control board or the entire regenerative unit if U4-06 exceeds 90%. For
instructions on replacing the control board, contact Yaskawa or a Yaskawa representative.
<1> If the fault occurs when starting the regenerative unit, CPF00 or CPF20 is displayed. If it occurs during operation, CPF01 or CPF21 is
displayed.
TOEP_C710656_08B_1_0.book 101 ページ ２０１５年２月５日 木曜日 午前１０時７分