HEIDENHAIN iTNC 530 (60642x-04) ISO programming - Manual (Page 633)

HEIDENHAIN iTNC 530 633
18
.1
Gener
al
user
par
amet
ers
Machining and program run
Effect of Cycle 11 SCALING FACTOR MP7410
SCALING FACTOR effective in three axes:
0
SCALING FACTOR effective in the working plane only: 1
Managing tool data/calibration data MP7411
The TNC saves the calibrated data for the touch probe internally:
+0
The TNC uses the compensation values for the touch probe from the tool
table as calibration data for the touch probe:
+1
SL cycles MP7420
The following applies to Cycles 21, 22, 23, 24:
Mill channel around the contour—clockwise for islands and
counterclockwise for pockets:
Bit 0 = 0
Mill channel around the contour—clockwise for pockets and
counterclockwise for islands:
Bit 0 = 1
First mill the channel, then rough out the contour: Bit 1 = 0
Rough out the contour, then mill the channel: Bit 1 = 1
Combine compensated contours: Bit 2 = 0
Combine uncompensated contours: Bit 2 = 1
Rough out to each pocket depth: Bit 3 = 0
Mill pocket and rough-out for each infeed depth before continuing to the
next depth:
Bit 3 = 1
The following applies to Cycles 6, 15, 16, 21, 22, 23, and 24:
At the end of the cycle, move the tool to the position that was last
programmed before the cycle call:
Bit 4 = 0
At the end of the cycle, retract the tool in the spindle axis only: Bit 4 = 1
Cycle 4 POCKET MILLING and Cycle 5
CIRCULAR POCKET MILLING: Overlap factor
MP7430
0.1 to 1.414
Permissible deviation of circle radius
between circle end point and circle starting
point
MP7431
0.0001 to 0.016 [mm]
Limit switch tolerance for M140 and M150 MP7432
Function inactive:
0
Tolerance for the distance by which the software limit switch may be
exceeded with M140/M150:
0.0001 to 1.0000
Operation of various miscellaneous
functions M
Note:
The k
V
factors for position loop gain are set by
the machine tool builder. Refer to your machine
manual.
MP7440
Program stop with M6:
Bit 0 = 0
No program stop with M6: Bit 0 = 1
No cycle call with M89: Bit 1 = 0
Cycle call with M89: Bit 1 = 1
Program stop with M functions: Bit 2 = 0
No program stop with M functions: Bit 2 = 1
k
V
factors cannot be switched through M105 and M106: Bit 3 = 0
k
V
factors can be switched through M105 and M106: Bit 3 = 1
Reduce the feed rate in the tool axis with M103 F..
Function inactive:
Bit 4 = 0
Reduce the feed rate in the tool axis with M103 F..
Function active:
Bit 4 = 1
Reserved: Bit 5
Exact stop for positioning with rotary axes inactive: Bit 6 = 0
Exact stop for positioning with rotary axes active: Bit 6 = 1