HEIDENHAIN iTNC 530 (60642x-04) ISO programming - Manual (Page 529)

HEIDENHAIN iTNC 530 529
14.9
W
or
kpiece
pr
eset
ting
with
a
to
uc
h
pr
obe
Finding the angle between the angle reference axis and a
workpiece edge
 Select the probe function by pressing the PROBING
ROT soft key
 Rotation angle: If you will need the current basic
rotation later, write down the value that appears
under Rotation angle
 Make a basic rotation with workpiece edge to be
compared (see "Compensating workpiece
misalignment with a 3-D touch probe" on page 516)
 Press the PROBING ROT soft key to display the angle
between the angle reference axis and the workpiece
edge as the rotation angle
 Cancel the basic rotation, or restore the previous basic
rotation
 Set the rotation angle to the value that you previously
wrote down
Measuring the angle between two workpiece edges
 Select the probe function by pressing the PROBING ROT soft key
 Rotation angle: If you need the current basic rotation later, write
down the displayed rotation angle
 Make a basic rotation with first workpiece edge (see "Compensating
workpiece misalignment with a 3-D touch probe" on page 516)
 Probe the second edge as for a basic rotation, but do not set the
rotation angle to zero!
 Press the PROBING ROT soft key to display the angle PA between
the workpiece edges as the rotation angle
 Cancel the basic rotation, or restore the previous basic rotation by
setting the rotation angle to the value that you wrote down
previously
PA
–10
100
a?
a?
L?
X
Z
Y
100