HEIDENHAIN iTNC 530 (60642x-04) ISO programming - Manual (Page 6)

TNC
model,
sof
tw
ar
e
and
feat
ur
es
6
TNC model, software and features
This manual describes functions and features provided by TNCs as of
the following NC software numbers.
The suffix E indicates the export version of the TNC. The export
versions of the TNC have the following limitations:
 Simultaneous linear movement in up to 4 axes
HSCI (HEIDENHAIN Serial Controller Interface) identifies the new
hardware platform of the TNC controls.
HEROS 5 identifies the operating system of HSCI-based TNC controls.
The machine tool builder adapts the usable features of the TNC to his
machine by setting machine parameters. Some of the functions
described in this manual may therefore not be among the features
provided by the TNC on your machine tool.
TNC functions that may not be available on your machine include:
 Tool measurement with the TT
Please contact your machine tool builder to become familiar with the
features of your machine.
Many machine manufacturers, as well as HEIDENHAIN, offer
programming courses for the TNCs. We recommend these courses as
an effective way of improving your programming skill and sharing
information and ideas with other TNC users.
TNC model NC software number
iTNC 530, HSCI and HEROS 5 606420-04
iTNC 530 E, HSCI and HEROS 5 606421-04
iTNC 530 programming station,
HEROS 5 606424-04
User's Manual for Cycle Programming:
All of the cycle functions (touch probe cycles and fixed
cycles) are described in a separate manual. Please contact
HEIDENHAIN if you require a copy of this User’s Manual.
ID: 670388-xx
smarT.NC user documentation:
The smarT.NC operating mode is described in a separate
Pilot. Please contact HEIDENHAIN if you require a copy of
this Pilot. ID: 533191-xx.