HEIDENHAIN iTNC 530 (60642x-04) ISO programming - Manual (Page 198)

198 Programming: Tools
5.2
Tool
data
In the new view, the TNC presents all tool information in the following
four tabs:
 Tools :
Tool specific information
 Tool pockets :
Pocket-specific information
 Tooling list :
List of all tools in the NC program that is selected in the Program
Run mode (only if you have already created a tool usage file, see
"Tool usage test", page 194). The TNC shows the tools missing in
the tooling list in the TOOL INFO column with the not defined dialog
marked in red
 T usage order :
List of the sequence of all tools that are inserted in the program
selected in the Program Run mode (only if you have already made a
tool usage file, see "Tool usage test", page 194) The TNC shows the
tools missing in the usage order list in the TOOL INFO column with
the not defined dialog marked in red
You can edit the tool data only in the form view, which you
can activate by pressing the FORM FOR TOOL soft key or
the ENT key for the currently highlighted tool.