HEIDENHAIN iTNC 530 (60642x-04) ISO programming - Manual (Page 157)

HEIDENHAIN iTNC 530 157
4.5
3-D
line
gr
aphics
(FCL2
function)
You can also use the mouse with the 3-D line graphics. The following
functions are available:
 In order to rotate the wire model shown in three dimensions: Hold
the right mouse button down and move the mouse. The TNC
displays a coordinate system showing the currently active
orientation of the workpiece. After you release the right mouse
button, the TNC orients the workpiece to the defined orientation
 In order to shift the wire model shown: Hold the center mouse
button or the wheel button down and move the mouse. The TNC
shifts the workpiece in the corresponding direction. After you
release the center mouse button, the TNC shifts the workpiece to
the defined position
 In order to zoom in on a certain area with the mouse: Draw a
rectangular zoom area while holding the left mouse button down.
You can shift the zoom area by moving the mouse horizontally and
vertically as required. After you release the left mouse button, the
TNC zooms in on the defined area of the workpiece
 In order to quickly zoom in and out with the mouse: Rotate the
wheel button forward or backward
 Double-click with the right mouse button: Select standard view
Rotate workpiece counterclockwise
Tilt workpiece backward
Tilt workpiece forward
Magnify the graphic stepwise If the view is
magnified, the TNC shows the letter Z in the
footer of the graphic window
Reduce the graphic stepwise If the view is
reduced, the TNC shows the letter Z in the footer
of the graphic window
Show workpiece at original size
Show workpiece in the last active view
Show/hide programmed end points with a dot on
the line
Do or do not highlight the selected NC block of
the 3-D line graphics in the left window
Do or do not show block numbers
Function Soft key