HEIDENHAIN iTNC 530 (60642x-04) ISO programming - Manual (Page 21)

Chang
ed
functions
in
60642x
-0
1
sinc
e
the
pr
edecessor
ve
rsions
34049x
-05
HEIDENHAIN iTNC 530 21
Changed functions in 60642x-01
since the predecessor versions
34049x-05
 In the calibration menus for touch probe length and radius, the
number and name of the active tool are also displayed now (if the
calibration data from the tool table are to be used, MP7411 = 1, see
"Managing more than one block of calibration data", page 515)
 During tilting in the Distance-To-Go mode, the PLANE function now
shows the angle actually left to be traversed until the target position
(see "Position display" on page 423)
 The approach behavior during side finishing with Cycle 24 (DIN/ISO:
G124) was changed (see User's Manual for Cycle Programming)