beautypg.com

HEIDENHAIN iTNC 530 (60642x-04) ISO programming User Manual

Page 502

background image

502

Manual Operation and Setup

14.5

W

o

rk

piece

pr

eset

ting

without

a

to

uc

h

pr

obe

Saving presets in the preset table
The preset table has the name PRESET.PR, and is saved in the directory
TNC:\.

PRESET.PR is editable only in the Manual Operation and

Electronic Handwheel

modes. In the Programming and Editing mode

you can only read the table, not edit it.

It is permitted to copy the preset table into another directory (for data
backup). Lines that were written by your machine tool builder are also
always write-protected in the copied tables. You therefore cannot edit
them.

Never change the number of lines in the copied tables! That could
cause problems when you want to reactivate the table.

To activate the preset table copied to another directory you have to
copy it back to the directory TNC:\.

There are several methods for saving presets and/or basic rotations in
the preset table:

Through probing cycles in the Manual Operation or El. Handwheel
modes (see Chapter 14)

Through the probing cycles 400 to 402 and 410 to 419 in automatic
mode (see User’s Manual, Cycles, Chapters 14 and 15)

Manual entry (see description below)