HEIDENHAIN iTNC 530 (60642x-04) ISO programming - Manual (Page 18)

New
functions
in
ve
rsion
60642x
-03
18
 Improvements to the file management:
 A preview function is now available in the file management (see
"Calling the file manager" on page 120)
 Additional setting possibilities are available in the file
management (see "Adapting the file manager" on page 135)
 Improvements to the global program settings (GS):
 The limit plane function is now available (see "Limit plane" on page
390)
 Improvements to the tool table TOOL.T:
 The contents of table rows can be copied and pasted by using soft
keys or shortcuts (see "Editing functions" on page 183)
 The new column ACC was introduced (see "Tool table: Standard
tool data" on page 175)
 The following additional functions are now available in the expanded
tool management:
 Graphic depiction of tool type in the table view and in the tool data
form (see "Tool management (software option)" on page 197)
 New function REFRESH VIEW for reinitializing a view if the data
stock is inconsistent (see "Operating the tool management" on
page 199)
 New function "Fill in the table" during the import of tool data (see
"Importing tool data" on page 202)
 The additional status display now has a new tab, in which the range
limits and the actual values of handwheel superimpositions are
displayed (see "Information on handwheel superimpositioning (POS
HR tab)" on page 85)
 A preview image that can be used to graphically select the startup
position is now available for mid-program startup in a point table (see
"Mid-program startup (block scan)" on page 567)
 With Cycle 256 RECTANGULAR STUD, a parameter is now available
with which you can determine the approach position on the stud
(see User's Manual for Cycle Programming).
 With Cycle 257, CIRCULAR STUD, a parameter is now available
with which you can determine the approach position on the stud
(see User's Manual for Cycle Programming)