HEIDENHAIN iTNC 530 (60642x-04) ISO programming User Manual
Page 11
New
functions
in
60642x
-0
1
since
the
pr
edecessor
ve
rsions
34049x
-05
HEIDENHAIN iTNC 530
11
New functions in 60642x-01 since
the predecessor versions 34049x-05
Opening and editing of externally created files has been added (see
"Additional tools for management of external file types" on page 139)
New functions in the task bar have been added (see "Task bar" on
page 90)
Enhanced functions for configuration of the Ethernet interface (see
"Configuring the TNC" on page 585)
Improvements regarding functional safety FS (option):
General information on functional safety (FS) (see "Miscellaneous"
on page 494)
Explanation of terms (see "Explanation of terms" on page 495)
Checking the axis positions (see "Checking the axis positions" on
page 496)
Activating feed-rate limitation (see "Activating feed-rate limitation"
on page 498)
Improvements regarding the general status view of a TNC with
functional safety (see "Additional status displays" on page 498)
The new HR 520 and HR 550 FS handwheels are supported (see
"Traversing with electronic handwheels" on page 482)
New software option 3-D ToolComp: 3-D tool radius compensation
depending on the tool’s contact angle on blocks with surface normal
vectors (LN blocks)
3-D line graphics now also possible in full-screen mode (see "3-D line
graphics (FCL2 function)" on page 156)
A file selection dialog for selecting files in different NC functions and
in the table view of the pallet table is available now (see "Calling any
program as a subprogram" on page 270)
DCM: Saving and restoring of fixture situations
DCM: The form for test program generation now also contains icons
and tooltips (see "Checking the position of the measured fixture" on
page 371)
DCM, FixtureWizard: Touch points and probing sequence are shown
more clearly now
DCM, FixtureWizard: Designations, touch points and measuring
points can be shown or hidden as desired (see "Operating
FixtureWizard" on page 368)
DCM, FixtureWizard: Chucking equipment and insertion points can
now also be selected by mouse click
DCM: A library with standard chucking equipment is available now
(see "Fixture templates" on page 367)
DCM: Tool carrier management (see "Tool carrier management
(DCM software option)" on page 376)