HEIDENHAIN iTNC 530 (340 422) ISO programming - Manual (Page 99)

HEIDENHAIN iTNC 530 99
4.5 Cr
eating
and
W
riting
Pr
ogr
ams
Creating a new part program
You always enter a part program in the Programming and Editing
mode of operation:
Select the Programming and Editing mode of
operation.
To call the file manager, press the PGM MGT key.
Select the directory in which you wish to store the new program:
Enter the new program name and confirm your entry
with the ENT key.
To select the unit of measure, press the MM or INCH
soft key. The TNC switches the screen layout and
initiates the dialog for defining the blank form.
Set the spindle axis (use the default setting G17 = Z
or, if required, select a different spindle axis using the
soft key) and confirm with the ENT key.
Enter in sequence the X, Y and Z coordinates of the
MIN point.
Define absolute/incremental input; can be defined
separately for each coordinate.
FILE NAME = OLD.H
SPINDLE AXIS?
COORDINATES ?
COORDINATES ?
0
0
-40