HEIDENHAIN iTNC 530 (340 422) ISO programming - Manual (Page 56)

56 2 Manual Operation and Setup
2.4 D
a
tu
m
Set
ting
(With
out a 3
-D T
ouc
h
Pr
ob
e)
Editing the preset table
Editing function in table mode Soft key
Select beginning of table
Select end of table
Select previous page in table
Select next page in table
Release/lock preset table for editing
In the selected line of the preset table, save the
datum that is active in the Manual operating
mode
Activate the datum of the selected line of the
preset table
Add the entered number of lines to the end of the
table (2nd soft-key row)
Copy the highlighted field (2nd soft-key row)
Insert the copied field (2nd soft-key row)
Reset the selected line: The TNC enters – in all
columns (2nd soft-key row)
Insert a single line at the end of the table
(2nd soft-key row)
Delete a single line at the end of the table
(2nd soft-key row)