HEIDENHAIN iTNC 530 (340 422) ISO programming - Manual (Page 316)

316 8 Programming: Cycles
8.4 Cy
cles f
o
r Mil
ling P
o
c
k
e
ts, St
ud
s an
d Slo
ts
U U U U Angle of rotation Q224 (absolute value): Angle by
which the entire slot is rotated. The center of rotation
lies in the center of the slot.
U U U U Infeed for finishing Q338 (incremental value):
Infeed per cut. Q338=0: Finishing in one infeed.
U U U U Feed rate for plunging Q206: Traversing speed of
the tool while moving to depth in mm/min. Only in
effect during finishing if an infeed for finishing has
been entered.