HEIDENHAIN iTNC 530 (340 422) ISO programming - Manual (Page 462)

462 11 Test Run and Program Run
11
.4
P
ro
g
ra
m
R
u
n Running a part program
Preparation
1 Clamp the workpiece to the machine table.
2 Set the datum.
3 Select the necessary tables and pallet files (status M).
4 Select the part program (status M).
Program Run, Full Sequence
U U U U Start the part program with the machine START button.
Program Run, Single Block
U U U U Start each block of the part program individually with the machine
START button.
You can adjust the feed rate and spindle speed with the
override knobs.
It is possible to reduce the rapid traverse speed when
starting the NC program using the FMAX soft key. The
entered value remains in effect even after the machine has
been turned off and on again. In order to re-establish the
original rapid traverse speed, you need to re-enter the
corresponding value.