HEIDENHAIN iTNC 530 (340 422) ISO programming - Manual (Page 141)

HEIDENHAIN iTNC 530 141
5.2 T
o
ol D
a
ta
Tool table: Tool data for automatic speed/feed rate calculation.
Tool table: Tool data for 3-D touch trigger probe (only when bit 1
is set in MP7411 = 1, also see the Touch Probe Cycles Manual)
Abbr. Input Dialog
TYPE Tool type (MILL for milling, DRILL for drilling or boring, TAP for
tapping): Press the SELECT TYPE soft key (3rd soft-key row): The
TNC superimposes a window where you can select the type of
tool you want. Tool type?
TMAT Tool material: Press the SELECT MATERIAL soft key (3rd soft-key
row): The TNC superimposes a window where you can select the
type of material you want. Tool material?
CDT Cutting data table: Press the SELECT CDT soft key (3rd soft-key
row): The TNC superimposes a window where you can select a
cutting data table. Name of cutting data table?
Abbr. Input Dialog
CAL-OF1 During calibration, the TNC stores in this column the center
misalignment in the reference axis of the 3-D probe, if a tool
number is indicated in the calibration menu. Center misalignmt. in ref. axis?
CAL-OF2 During calibration, the TNC stores in this column the center
misalignment in the minor axis of the 3-D probe, if a tool number
is indicated in the calibration menu. Center misalignment minor axis?
CAL-ANG During calibration, the TNC stores in this column the spindle angle
at which the 3-D probe was calibrated, if a tool number is
indicated in the calibration menu. Spindle angle for calibration?