Selecting a pallet table, Leaving the pallet file, Executing the pallet file – HEIDENHAIN iTNC 530 (340 422) ISO programming User Manual
Page 121: 12 p a llet manag e ment
HEIDENHAIN iTNC 530
121
4.12 P
a
llet Manag
e
ment
Selecting a pallet table
U
U
U
U
Call the file manager in the Programming and Editing or Program
Run mode: Press the PGM MGT key.
U
U
U
U
To display all type .P files, press the soft keys SELECT TYPE and
SHOW .P.
U
U
U
U
Select a pallet table with the arrow keys, or enter a new file name
to create a new table.
U
U
U
U
Confirm your entry with the ENT key.
Leaving the pallet file
U
U
U
U
To call the file manager, press the PGM MGT soft key.
U
U
U
U
To select a different type of file, press the SELECT TYPE soft key
and the soft key for the desired file type, for example SHOW.H.
U
U
U
U
Select the desired file.
Executing the pallet file
U
U
U
U
Select the file manager in the Program Run, Full Sequence or
Program Run, Single Block operating modes: Press the PGM MGT
key.
U
U
U
U
To display all type .P files, press the soft keys SELECT TYPE and
SHOW .P.
U
U
U
U
Select the pallet table with the arrow keys and confirm with ENT.
U
U
U
U
To execute the pallet table: Press the NC Start button. The TNC
executes the pallets as set in MP7683.
Programs executed over the pallet file must not contain
M30 (M02).
In MP7683, set whether the pallet table is to be executed
blockwise or continuously (see “General User
Parameters” on page 506).