HEIDENHAIN iTNC 530 (340 422) ISO programming - Manual (Page 235)

HEIDENHAIN iTNC 530 235
8.3 Cy
cles f
o
r Dr
illing
, T
a
p
p
ing
and
Th
read Millin
g REAMING (Cycle G201)
1 The TNC positions the tool in the tool axis at rapid traverse to the
programmed setup clearance above the workpiece surface.
2 The tool reams to the entered depth at the programmed feed
rate F.
3 If programmed, the tool remains at the hole bottom for the entered
dwell time.
4 The tool then retracts to the set-up clearance at the feed rate F,
and from there—if programmed—to the 2nd set-up clearance at
rapid traverse.
X
Z
Q200
Q201
Q206
Q211
Q203
Q204
Q208
Before programming, note the following:
Program a positioning block for the starting point (hole
center) in the working plane with radius compensation
G40.
The algebraic sign for the cycle parameter DEPTH
determines the working direction. If you program
DEPTH = 0, the cycle will not be executed.
Enter in MP7441 bit 2 whether the TNC should output an
error message (bit 2=1) or not (bit 2=0) if a positive depth
is entered.
Danger of collision!
Keep in mind that the TNC reverses the calculation for pre-
positioning when a positive depth is entered. This
means that the tool moves at rapid traverse in the tool axis
at safety clearance below the workpiece surface!