HEIDENHAIN SW 54843x-02 DIN Programming - Manual (Page 86)

86 smart.Turn units
2.5 Units—Dr
illing in C axis
"Tapping, face" unit
This unit machines a single tap hole on the face of the workpiece.
Unit name: G73_Gew_Stirn_C / Cycle: G73 (see page 316)
Use the retraction length for floating tap holders. The cycle
calculates a new nominal pitch on the basis of the thread depth, the
programmed pitch, and the retraction length. The nominal pitch is
somewhat smaller than the pitch of the tap. During tapping, the tap is
pulled away from the chuck by the retraction length. With this method
you can achieve higher service life from taps.
Access to the technology database:
 Machining operation: Tapping
 Affected parameter: S
Cycle form
Z1
Start point drill (starting point of hole)
Z2 End point drill (end point of hole)
CS Spindle angle
F1 Thread pitch
B Run-in length
L Retraction length when using floating tap holders
(default: 0)
SR Retraction speed (default: Shaft speed for tapping)
Further forms: see page 56