HEIDENHAIN SW 54843x-02 DIN Programming - Manual (Page 575)

HEIDENHAIN MANUALplus 620, CNC PILOT 640 575
9.4 Units—"Milling in C axis" gr
oup
9.4 Units—"Milling in C
axis" group
"Milling in C-axis, face" group
"ICP milling in C axis, face" group
Unit Description Page
G791_Nut_Stirn_C G791 Linear slot
Milling a linear slot
Page 127
G791_Lin_Stirn_C G791 Linear slot pattern
Milling of linear slots in a linear pattern
Page 128
G791_Cir_Stirn_C G791 Circular slot pattern
Milling of linear slots in a circular pattern
Page 129
G797_STIRNFR_C G797 Face milling
Milling various figures as islands
Page 130
G799_GewindeFR_C G799 Thread milling
Inside thread milling in a single hole
Page 131
G840_FIG_STIRN_C G840 Contour milling, figures
Milling figures inside, outside and on the contour
Page 132
G84X_FIG_STIRN_C G84x Pocket milling, figures
Roughing out closed figures, inside
Page 135
G801_GRA_STIRN_C G801 Engraving
Engraving characters strings on the face
Page 138
Unit Description Page
G840_Kon_C_STIRN G840 Contour milling, ICP
Machining ICP contours on the face inside, outside and on the contour
Page 134
G845_TAS_C_STIRN G845 Pocket milling, ICP
Inside rough-out of closed ICP contours on the face
Page 137
G840_ENT_C_STIRN G840 Deburring
Deburring ICP contours on the face
Page 139