HEIDENHAIN SW 54843x-02 DIN Programming - Manual (Page 149)

HEIDENHAIN MANUALplus 620, CNC PILOT 640 149
2.1
0
Units—Milling, lat
e
ra
l surf
ace
"ICP pocket milling, lateral surface" unit
The unit mills the pocket defined by Q. In QK, select the machining
operation (roughing/finishing) and the plunging strategy.
Unit name: G845_Tas_C_Mant / Cycles: G845 (see page 358); G846
(see page 362)
Access to the technology database:
 Machining operation: Milling
 Affected parameters: F, S, FZ, P
Contour form
FK
see page 58
NS Starting block no. of contour
NE End block no. of contour
X1 Milling top edge (diameter value)
P2 Depth of contour
NF Position mark (only if QK=8)
Cycle form
QK
Machining operation and plunging strategy
 0: Roughing
 1: Finishing
 2: Helical roughing, manual
 3: Helical roughing, automatic
 4: Reciprocating linear roughing, manual
 5: Reciprocating linear roughing, automatic
 6: Reciprocating circular roughing, manual
 7: Reciprocating circular roughing, automatic
 8: Plunge roughing at predrilling position
 9: Finishing with 3-D approach arc
JT Machining direction
 0: From the inside out (from the inside towards the
outside)
 1: From the outside in (from the outside towards the
inside)
H Cutting direction
 0: Up-cut milling
 1: Climb milling
P Maximum infeed
I Infeed-direction oversize
K Contour-parallel oversize
FZ Infeed factor
E Reduced feed rate
R Approach radius
WB Plunging length
EW Plunging angle
U Overlap factor (default: 0.5)
RB Return plane (diameter value)
Further forms: see page 56