HEIDENHAIN SW 54843x-02 DIN Programming - Manual (Page 470)

470 Touch probe cycles
5.8 Angular measur
ement
Misalignment compensation after angle
measurement G788
Cycle G788 activates a misalignment compensation determined with
Cycle G787 Angle Measurement.
Example: G788 Misalignment compensation after
angle measurement
. . .
MACHINING
N3 G788 NF1 P0
. . .
Parameters
NF
Result variable no.: Number of the first global variable in which
the result is saved (no entry = variable 810). The second
measurement result is saved automatically under the next
consecutive number.
P Compensation
 0: OFF: Do not perform misalignment compensation
 1: ON: Perform misalignment compensation