HEIDENHAIN SW 54843x-02 DIN Programming - Manual (Page 556)

556 TURN PLUS
7.
6 F
u
ll-surf
ace mac
h
ining with TURN PLUS
7.6 Full-surface machining with
TURN PLUS
Rechucking the workpiece
TURN PLUS provides three full-surface machining variants:
 Rechucking the workpiece in the main spindle. Both setups are
contained in one NC program.
 Transferring the workpiece from the main spindle to the opposing
spindle (chuck part).
 Parting and picking-off the workpiece with the opposing spindle.
TURN PLUS selects the required rechucking variant on the basis of the
fixture and the machining sequence.
The control uses subprograms for rechucking, which are
adapted by the machine tool builder. The functions and
sequences described below are examples—the behavior
of your machine may be different. Refer to your machine
manual.
For every rechucking variant, a separate subprogram that
controls the rechucking sequence is defined in the user
parameters (Processing/ExpertPrograms/Expert
programs).