HEIDENHAIN SW 54843x-02 DIN Programming - Manual (Page 156)

156 smart.Turn units
2.1
1
Units—Special oper
ations
"Program section repeat" unit
Use the Repeat unit to program a program section repeat. The unit
consists of two inseparable parts. Program the unit with the Begin
form immediately before the repeatable part, and the unit with the End
form immediately behind the repeatable part. Be sure to use the same
variable number here.
Unit name: REPEAT / Called cycle: None
"Start" form
AE
Repetition
 0: Beginning
 1: End
V Variable number 1–30 (counting variable for the iteration
loop)
NN Number of repetitions
QR Save workpiece blank
 0: No
 1: Yes
K Comment
"End" form
AE
Repetition:
 0: Beginning
 1: End
V Variable number 1–30 (counting variable for the iteration
loop)
Z Additive datum shift
C Incremental shift, C axis
Q Number of the C axis
K Comment