HEIDENHAIN SW 54843x-02 DIN Programming - Manual (Page 570)

570 Overview of units
9.1 Units—"T
u
rn
ing" gr
oup
9.1 Units—"Turning" group
"Roughing" group
"Finishing" group
Unit Description Page
G810_ICP G810 Longitudinal in ICP
Roughing an ICP contour longitudinally
Page 63
G820_ICP G820 Transverse in ICP
Roughing an ICP contour transversely
Page 64
G830_ICP G830 Contour parallel in ICP
Roughing parallel to the contour in ICP
Page 65
G835_ICP G835 Bidirectional in ICP
Roughing an ICP contour in two directions
Page 66
G810_G80 G810 Longitudinal, direct
Longitudinal roughing with direct contour input
Page 67
G820_G80 G820 Transverse, direct
Transverse roughing with direct contour input
Page 68
Unit Description Page
G890_ICP G890 Contouring in ICP
Finishing an ICP contour
Page 113
G890_G80_L G890 Contouring, direct longitdnl.
Longitudinal finishing with direct contour input
Page 115
G890_G80_P G890 Contouring, direct transverse
Transverse finishing with direct contour input
Page 116
G85x_DIN_E_F_G G890 Relief, type E, F, DIN76
Finishing the undercuts according to DIN509 type E and F and the thread
undercut DIN76
Page 117