HEIDENHAIN SW 54843x-02 DIN Programming - Manual (Page 126)

126 smart.Turn units
2.8 Units—Thr
eads
Cycle form
I
Maximum infeed (radius)
IC Number of cuts (only if I is not programmed)
H Kind of displacement (type of offset; offset between the
individual infeeds in cutting direction)
 0: Without offset
 1: From left
 2: From right
 3: Alternately left/right
V Type of infeed
 0: Constant mach. X-section
 1: Constant infeed
 2: W/ remaining cutting (with distribution of remaining
cuts)
 3: W/o remaining cutting (without distribution of
remaining cuts)
 4: Same as MANUALplus 4110
 5: Constant infeed (same as 4290)
 6: Constant with remaining cutting (same as 4290)
A Approach angle (angle of infeed; reference in X axis
0°
R Remaining cut depth (only with V=4)
C Starting angle
D No. of gears (threads per unit)
Q No. no load (number of dry runs)
Further forms: see page 56