HEIDENHAIN SW 54843x-02 DIN Programming - Manual (Page 362)

362 DIN programming
4.26 Milling cy
cles
Pocket milling, finishing G846
G846 finish-machines closed contours.
If the pocket consists of multiple sections, G846 takes all the sections
of the pocket into account.
You can change the cutting direction with the cutting direction H,
the machining direction Q and the direction of tool rotation (see
following table).
Parameters—finishing
ID
Milling contour—name of the contour to be milled
NS Starting block no. of contour
 Figures: Block number of the figure
 Free closed contour: A contour element (not starting point)
B Milling depth (default: depth from the contour description)
P (Maximum) infeed (default: milling in one infeed)
XS Milling top edge—lateral surface (replaces the reference plane
from the contour definition)
ZS Milling top edge—face (replaces the reference plane from the
contour definition)
R Radius of approaching/departing arc (default: 0)
 R=0: Contour element is approached directly. Feed to the
starting point above the milling plane, then vertical plunge.
 R>0: Tool moves on approaching/departing arc that
connects tangentially to the contour element.
U (Minimum) overlap factor. Defines the overlap of milling paths
(default: 0.5).
Overlap = U*milling diameter
V Overrun factor—no effect with C-axis machining
H Cutting direction (default: 0)
 0: Up-cut milling
 1: Climb milling
F Feed rate for infeed (default: active feed rate)
E Reduced feed rate for circular elements (default: current feed
rate)
RB Retraction plane (default: back to starting position)
 Front or rear face: Return position in Z direction
 Lateral surface: Return position in X direction (diameter)