HEIDENHAIN SW 54843x-02 DIN Programming - Manual (Page 18)

18
4.13 Zero point shifts ..... 249
Zero point shift G51 ..... 250
Additive zero point shift G56 ..... 251
Absolute zero point shift G59 ..... 252
4.14 Oversizes ..... 253
Switch off oversize G50 ..... 253
Axis-parallel oversize G57 ..... 253
Contour-parallel oversize (equidistant) G58 ..... 254
4.15 Safety clearances ..... 255
Safety clearance G47 ..... 255
Safety clearance G147 ..... 255
4.16 Tools, compensations ..... 256
Tool call T ..... 256
Correction of cut (switching the tool edge compensation) G148 ..... 257
Additive compensation G149 ..... 258
Compensation of right-hand tool tip G150
Compensation of left-hand tool tip G151 ..... 259
4.17 Contour-based turning cycles ..... 260
Working with contour-based cycles ..... 260
Longitudinal roughing G810 ..... 262
Face roughing G820 ..... 265
Contour-parallel roughing G830 ..... 268
Contour cycle, bidirectional (contour-parallel with neutral tool) G835 ..... 271
Recessing G860 ..... 273
Repeat recessing cycle G740/G741 ..... 275
Recess turning cycle G869 ..... 276
Recessing cycle G870 ..... 279
Finish contour G890 ..... 280
Measuring cut G809 ..... 283
4.18 Contour definitions in the machining section ..... 284
Cycle end / Simple contour G80 ..... 284
Linear slot on front/rear face G301 ..... 285
Circular slot on front/rear face G302/G303 ..... 285
Full circle on front/rear face G304 ..... 286
Rectangle on front/rear face G305 ..... 286
Eccentric polygon on front/rear face G307 ..... 287
Linear slot on lateral surface G311 ..... 287
Circular slot on lateral surface G312/G313 ..... 288
Full circle, lateral surface G314 ..... 288
Rectangle, lateral surface G315 ..... 289
Eccentric polygon, lateral surface G317 ..... 289