HEIDENHAIN SW 54843x-02 DIN Programming - Manual (Page 294)

294 DIN programming
4.1
9
Thr
ead cy
cles
Cycle run
1
Calculates the number of cutting passes.
2 Returns diagonally to the internal starting point at rapid traverse.
This point lies in front of the "starting point of thread" by the run-
in length B. With H=1 (or 2, 3) the current offset is taken into
account for calculating the internal starting point.
The internal starting point is calculated on the basis of the tool
tip.
3 Accelerates to feed rate (line B).
4 Executes a thread cut.
5 Decelerates (line P).
6 Retracts to safety clearance, returns at rapid traverse, and
approaches for next pass. For multiple threads, the same rate of
cut is used for each thread turn, before the next infeed motion
is executed.
7 Repeats 3 to 6 until the complete thread has been cut.
8 Executes air cuts.
9 Returns to starting point.