HEIDENHAIN SW 54843x-02 DIN Programming - Manual (Page 38)

38 NC programming
1
.2 The smar
t.T
u
rn
edit
or
Shared menu items
The menu items described below are used both in smart.Turn mode
and in DIN/ISO mode.
"Program management" pull-down menu
The "Prog" pull-down menu (program management) contains the
following functions for NC main and subprograms:
 Open: Load existing programs
 New: Create new programs
 Close: The selected program is closed
 Close All: All open programs are closed
 Save: The selected program is saved
 Save As: The selected program is saved under a new name
 Direct opening of the last four programs
When an NC program is opened or when a new NC program is
created, the soft-key row is switched to the sorting and organization
functions. See "Sorting, file organization" on page 43..
"Head" pull-down menu (program head)
The "Head" pull-down menu (program head) contains functions for
editing the program head and the tool list.
 Program head: Edit the program head
 Go to chucking equipment: Positions the cursor in the "chucking
equipment" section
 Insert chucking equipment: Describe how the workpiece is
clamped
 Go to tool list: Positions the cursor in the TURRET section
 Set up the tool list: Activates the "Set up tool list" function (see
page 51)
"ICP" pull-down menu
The "ICP" pull-down menu (Interactive Contour Programming)
contains the following functions:
 Contour editing: Change the current contour (cursor position)
 Workpiece blank: Edit the description of the workpiece blank
 Finished part: Edit the description of the finished part
 New auxiliary blank: Create a new auxiliary workpiece blank
 New aux. contour: Create a new auxiliary contour
 C axis ...: Create patterns and milling contours on the front face and
lateral surface
 Y axis ...: Create patterns and milling contours in the XY and YZ
planes