HEIDENHAIN SW 54843x-02 DIN Programming - Manual (Page 36)

36 NC programming
1
.2 The smar
t.T
u
rn
edit
or
1.2 The smart.Turn editor
Menu structure
You can select the following editor modes in the smart.Turn editor:
 Unit programming (standard)
 DIN/ISO mode (DIN PLUS and DIN 66025)
The menu structure of the smart.Turn editor is shown in the illustration
at right. Many menu items are used in both modes. The menus differ
in the area of geometry and part programming. In DIN/ISO mode the
menu items "Geo(metry)" and "Mach(ining)" are displayed instead of
the menu items "ICP" and "Units" (see illustrations at lower right). You
can switch between the editor modes by soft key.
 Switches between the Unit mode and DIN/ISO mode
For special cases you can change to the text-editor mode in order to
edit character-by-character without syntax checking. The setting is
made in the Configuration / Input mode menu item.
For a description of the functions, please refer to the following
chapters:
 Shared menu items: See "Menu structure" on page 36.
 ICP functions: Chapter 5 in the User's Manual
 Units for turning and C-axis machining: See "smart.Turn units" on
page 55.
 Units for Y-axis machining: See "smart.Turn units for the Y axis" on
page 159.
 G codes for turning and C-axis machining (geometry and machining):
See "DIN programming" on page 181.
 G codes for Y-axis machining (geometry and machining): See "DIN
programming for the Y axis" on page 475.