Grass Valley PDR v.2.2 - Manual (Page 71)

Serial Digital Component Video Input Advanced
Profile Family 53
NOTE: If you select auto-timing for an input signal and it cannot
auto time with the genlock reference signal, the input signal is not
recorded accurately. If you must record an input that cannot lock,
disable auto timing and record. There may be problems if you are
operating in E to E mode, but the clip plays back correctly timed.
If auto-timing is enabled, and the signal was able to be timed into the system,
the Auto Timed indicator is turned on. Also, Line 1 can still be adjusted, but
Line 2 is always equal to Line 1 + 14.
Enable Dither
Dithering smooths out roughness caused when a signal is digitized. The LSB
artifacts on 10-bit video feeds are reduced. There is no effect on 8-bit video.
Serial Digital Component Video Input Advanced
Click the Advanced tab to view the Serial Digital Component Video Input
Advanced settings.
Figure 27. Serial Digital Component Video Input, Advanced tab
These advanced settings allow you to determine whether the EDH packet is
present, which audio groups are present, and which errors are present: Full
Field (FF) CRC or Active Picture (AP) CRC, plus parity and checksum errors.