Grass Valley PDR v.2.2 - Manual (Page 154)

Chapter 4 Using VdrPanel
136 Profile Family
Selecting Clip Length (BVW Only)
If you have chosen a BVW controller, you can specify clip length by setting
mark in and mark out points:
NOTE: The Set Clip Marks (clip length) dialog box shown here will
not appear unless the panel controller is a BVW controller.
1. Click a panel to select it.
2. Choose Controller | Clip Length . The Set Clip Marks dialog box appears
(Figure 74).
Figure 74. Set Clip Marks dialog box
3. Enter the mark-in and mark-out points by specifying the hour, minute,
second, and frame settings. This applies to future clips only.
4. Click Apply to Loaded Clip(s ) if you want the mark-in and mark-out points to
apply to existing clips as well as future clips.
5. Click OK when complete.