Grass Valley PDR v.2.2 User Manual
Page 160
Chapter 4
Using VdrPanel
142
Profile Family
NOTE: There must be two audio codecs assigned for each audio
track to be recorded.
5. Select two pairs of timecode. For example, select
TCREC #5
and
TCREC #7
for the
Playback Timecode
and
TCREC #6
and
TCREC #8
for the
Record
Timecode
.
6. If any other selections are highlighted, click to deselect them.
7. Select the video compression to be applied; see “Setting Compression
Presets” on page 139 for more information on video compression and the
presets.
8. Click
OK
.
9. Choose
Controller | Comm Port
to open the Communication Port dialog box
10. Select the RS-422 communication port to be used for the edit controller—for
example,
P3
. The
Port
name is the same as the name on the RS-422 breakout
box.
11. Click
OK
.
12. Verify the external connections:
- Source audio channels are connected to the inputs for the audio channels
assigned as the
Record Audio
.
- Audio outputs from the disk recorder are connected to the audio channels
assigned as the
Playback Audio
.
- Edit controller is connected to the assigned
Port
. Refer to the your
system’s installation manual.
- DIP switch on the breakout box is set to Device for the RS-422 Port. Refer
to the unit’s installation manual.