H3C Technologies H3C S7500E Series Switches User Manual
Page 98
7-27
[DeviceC-rrpp-domain1] quit
# Enable RRPP.
[DeviceC] rrpp enable
4) Configuration on Device D
# Set the physical state change suppression interval on GigabitEthernet2/0/1 and
GigabitEthernet2/0/2 to 0 seconds, disable STP, configure the two ports as trunk ports, and
assign them to all VLANs.
[DeviceD] interface gigabitethernet 2/0/1
[DeviceD-GigabitEthernet2/0/1] link-delay 0
[DeviceD-GigabitEthernet2/0/1] undo stp enable
[DeviceD-GigabitEthernet2/0/1] port link-type trunk
[DeviceD-GigabitEthernet2/0/1] port trunk permit vlan all
[DeviceD-GigabitEthernet2/0/1] quit
[DeviceD] interface gigabitethernet 2/0/2
[DeviceD-GigabitEthernet2/0/2] link-delay 0
[DeviceD-GigabitEthernet2/0/2] undo stp enable
[DeviceD-GigabitEthernet2/0/2] port link-type trunk
[DeviceD-GigabitEthernet2/0/2] port trunk permit vlan all
[DeviceD-GigabitEthernet2/0/2] quit
# Create RRPP domain 1, configure VLAN 4092 as the primary control VLAN of RRPP domain 1,
and configure VLANs mapped to MSTIs 0 through 31 as the protected VLANs of RRPP domain
1.
[DeviceD] rrpp domain 1
[DeviceD-rrpp-domain1] control-vlan 4092
[DeviceD-rrpp-domain1] protected-vlan reference-instance 0 to 31
# Configure Device D as the transit node of primary ring 1, with GigabitEthernet 2/0/1 as the
primary port and GigabitEthernet 2/0/2 as the secondary port, and enable ring 1.
[DeviceD-rrpp-domain1] ring 1 node-mode transit primary-port gigabitethernet 2/0/1
secondary-port gigabitethernet 2/0/2 level 0
[DeviceD-rrpp-domain1] ring 1 enable
[DeviceD-rrpp-domain1] quit
# Enable RRPP.
[DeviceD] rrpp enable
5) Configuration on Device E
# Set the physical state change suppression interval on GigabitEthernet2/0/1 and
GigabitEthernet2/0/2 to 0 seconds, disable STP, configure the two ports as trunk ports, and
assign them to all VLANs.
[DeviceE] interface gigabitethernet 2/0/1
[DeviceE-GigabitEthernet2/0/1] link-delay 0
[DeviceE-GigabitEthernet2/0/1] undo stp enable
[DeviceE-GigabitEthernet2/0/1] port link-type trunk
[DeviceE-GigabitEthernet2/0/1] port trunk permit vlan all
[DeviceE-GigabitEthernet2/0/1] quit
[DeviceE] interface gigabitethernet 2/0/2
[DeviceE-GigabitEthernet2/0/2] link-delay 0
[DeviceE-GigabitEthernet2/0/2] undo stp enable