Intersecting ring configuration example, Networking requirements – H3C Technologies H3C S7500E Series Switches User Manual
Page 94
7-23
[DeviceA-rrpp-domain1] ring 1 enable
[DeviceA-rrpp-domain1] quit
# Enable RRPP.
[DeviceA] rrpp enable
2) Configuration on Device B
# Set the physical state change suppression interval on GigabitEthernet2/0/1 and
GigabitEthernet2/0/2 to 0 seconds, disable STP, configure the two ports as trunk ports, and
assign them to all VLANs.
[DeviceB] interface gigabitethernet 2/0/1
[DeviceB-GigabitEthernet2/0/1] link-delay 0
[DeviceB-GigabitEthernet2/0/1] undo stp enable
[DeviceB-GigabitEthernet2/0/1] port link-type trunk
[DeviceB-GigabitEthernet2/0/1] port trunk permit vlan all
[DeviceB-GigabitEthernet2/0/1] quit
[DeviceB] interface gigabitethernet 2/0/2
[DeviceB-GigabitEthernet2/0/2] link-delay 0
[DeviceB-GigabitEthernet2/0/2] undo stp enable
[DeviceB-GigabitEthernet2/0/2] port link-type trunk
[DeviceB-GigabitEthernet2/0/2] port trunk permit vlan all
[DeviceB-GigabitEthernet2/0/2] quit
# Create RRPP domain 1, configure VLAN 4092 as the primary control VLAN of RRPP domain 1,
and configure the VLANs mapped to MSTIs 0 through 31 as the protected VLANs of RRPP
domain 1.
[DeviceB] rrpp domain 1
[DeviceB-rrpp-domain1] control-vlan 4092
[DeviceB-rrpp-domain1] protected-vlan reference-instance 0 to 31
# Configure Device B as the transit node of primary ring 1, with GigabitEthernet 2/0/1 as the
primary port and GigabitEthernet 2/0/2 as the secondary port, and enable ring 1.
[DeviceB-rrpp-domain1] ring 1 node-mode transit primary-port gigabitethernet 2/0/1
secondary-port gigabitethernet 2/0/2 level 0
[DeviceB-rrpp-domain1] ring 1 enable
[DeviceB-rrpp-domain1] quit
# Enable RRPP.
[DeviceB] rrpp enable
3) Configuration on Device C
The configuration on Device C is similar to that on Device B and thus omitted here.
4) Configuration on Device D
The configuration on Device D is similar to that on Device B and thus omitted here.
5) Verification
After the above configuration, you can use the display command to view RRPP configuration
and operational information on each device.
Intersecting Ring Configuration Example
Networking requirements
As shown in
,