Protocols and standards, Rrpp configuration task list – H3C Technologies H3C S7500E Series Switches User Manual
Page 82
7-11
Domain 2. With the configurations, you can enable traffic of different VLANs to travel over
different paths in the subring and primary ring, thus achieving intersecting-ring load balancing.
Figure 7-7 Schematic diagram for an intersecting-ring load balancing network
Protocols and Standards
RFC 3619 Extreme Networks' Ethernet Automatic Protection Switching (EAPS) Version 1 is
related to RRPP.
RRPP Configuration Task List
You can create RRPP domains based on service planning, specify control VLANs and data
VLANs for each RRPP domain, and then determine the ring roles and node roles based on the
traffic paths in each RRPP domain.
Complete the following tasks to configure RRPP:
Task
Remarks
Required
Perform this task on all nodes in the RRPP domain.
Required
Perform this task on all nodes in the RRPP domain.
Required
Perform this task on all nodes in the RRPP domain.
Required
Perform this task on all nodes in the RRPP domain.
Required
Perform this task on all nodes in the RRPP domain
Required
Perform this task on all nodes in the RRPP domain.