H3C Technologies H3C S7500E Series Switches - Manual (Page 109)

7-38
[DeviceA-rrpp-domain1] timer fast-fail-timer 300
[DeviceA-rrpp-domain1] timer fast-hello-timer 100
[DeviceA-rrpp-domain1] quit
# Enable the RRPP protocol.
[DeviceA] rrpp enable
2) Configuration on Device B
# Set the physical state change suppression interval on GigabitEthernet 2/0/1 and
GigabitEthernet 2/0/2 to 0 seconds, disable STP, configure the two ports as trunk ports, and
assign them to all VLANs.
system-view
[DeviceB] interface gigabitethernet 2/0/1
[DeviceB-GigabitEthernet2/0/1] link-delay 0
[DeviceB-GigabitEthernet2/0/1] undo stp enable
[DeviceB-GigabitEthernet2/0/1] port link-type trunk
[DeviceB-GigabitEthernet2/0/1] port trunk permit vlan all
[DeviceB-GigabitEthernet2/0/1] quit
[DeviceB] interface gigabitethernet 2/0/2
[DeviceB-GigabitEthernet2/0/2] link-delay 0
[DeviceB-GigabitEthernet2/0/2] undo stp enable
[DeviceB-GigabitEthernet2/0/2] port link-type trunk
[DeviceB-GigabitEthernet2/0/2] port trunk permit vlan all
3) Configuration on Device C
# Set the physical state change suppression interval on GigabitEthernet 2/0/1 and
GigabitEthernet 2/0/2 to 0 seconds, disable STP, configure the two ports as trunk ports, and
assign them to all VLANs.
system-view
[DeviceC] interface gigabitethernet 2/0/1
[DeviceC-GigabitEthernet2/0/1] link-delay 0
[DeviceC-GigabitEthernet2/0/1] undo stp enable
[DeviceC-GigabitEthernet2/0/1] port link-type trunk
[DeviceC-GigabitEthernet2/0/1] port trunk permit vlan all
[DeviceC-GigabitEthernet2/0/1] quit
[DeviceC] interface gigabitethernet 2/0/2
[DeviceC-GigabitEthernet2/0/2] link-delay 0
[DeviceC-GigabitEthernet2/0/2] undo stp enable
[DeviceC-GigabitEthernet2/0/2] port link-type trunk
[DeviceC-GigabitEthernet2/0/2] port trunk permit vlan all
4) Configuration on Device D
# Set the physical state change suppression interval on GigabitEthernet 2/0/1 and
GigabitEthernet 2/0/2 to 0 seconds, disable STP, configure the two ports as trunk ports, and
assign them to all VLANs.
system-view
[DeviceD] interface gigabitethernet 2/0/1
[DeviceD-GigabitEthernet2/0/1] link-delay 0
[DeviceD-GigabitEthernet2/0/1] undo stp enable
[DeviceD-GigabitEthernet2/0/1] port link-type trunk
[DeviceD-GigabitEthernet2/0/1] port trunk permit vlan all
[DeviceD-GigabitEthernet2/0/1] quit