H3C Technologies H3C S7500E Series Switches - Manual (Page 26)

3-7
Configuring Basic Ethernet OAM Functions
As for Ethernet OAM connection establishment, a device can operate in active mode or passive mode.
After Ethernet OAM is enabled on an Ethernet port, according to its Ethernet OAM mode, the Ethernet
port establishes an Ethernet OAM connection with its peer port.
Follow these steps to configure basic Ethernet OAM functions:
To do… Use the command… Remarks
Enter system view System-view —
Enter Ethernet port view
interface interface-type
interface-number
—
Set Ethernet OAM operating mode oam mode { active | passive }
Optional
The default is active Ethernet OAM
mode.
Enable Ethernet OAM on the
current port
oam enable
Required
Ethernet OAM is disabled by
default.
To change the Ethernet OAM operating mode on an Ethernet OAM-enabled port, you need to first
disable Ethernet OAM on the port.
Configuring Link Monitoring
After Ethernet OAM connections are established, the link monitoring periods and thresholds
configured in this section take effect on all Ethernet ports automatically.
Configuring Errored Frame Event Detection
An errored frame event occurs when the number of detected error frames over a specific interval
exceeds the predefined threshold.
Follow these steps to configure errored frame event detection: