Configuration procedure, Pim-sm overview – H3C Technologies H3C S12500-X Series Switches User Manual
Page 98

88
Figure 32 Network diagram
Table 6 Interface and IP address assignment
Device Interface
IP
address
Switch A
VLAN-interface 100
10.110.1.1/24
Switch A
VLAN-interface 103
192.168.1.1/24
Switch B
VLAN-interface 200
10.110.2.1/24
Switch B
VLAN-interface 101
192.168.2.1/24
Switch C
VLAN-interface 200
10.110.2.2/24
Switch C
VLAN-interface 102
192.168.3.1/24
Switch D
VLAN-interface 300
10.110.5.1/24
Switch D
VLAN-interface 103
192.168.1.2/24
Switch D
VLAN-interface 101
192.168.2.2/24
Switch D
VLAN-interface 102
192.168.3.2/24
Configuration procedure
1.
Configure the IP address and subnet mask for each interface as per
. (Details not shown.)
2.
Configure OSPF on the switches in the PIM-DM domain to make sure the following conditions are
met: (Details not shown.)
{
The switches are interoperable at the network layer.
{
The switches can dynamically update their routing information.
3.
Enable IP multicast routing, IGMP, and PIM-DM:
# On Switch A, enable IP multicast routing.
- H3C S9800 Series Switches H3C S5560 Series Switches H3C S5130 Series Switches H3C S5120 Series Switches H3C S12500 Series Switches H3C SR8800 H3C SR6600-X H3C SR6600 H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C WX3000 Series Unified Switches H3C LSWM1WCM10 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module