Solution, Enabling mld fast-leave processing, Displaying and maintaining mld – H3C Technologies H3C S12500-X Series Switches User Manual
Page 201
191
Solution
1.
Use display ipv6 routing-table to verify that the IPv6 unicast routes to the C-RPs and the BSR are
available on each router and that a route is available between each C-RP and the BSR. Make sure
each C-RP has an IPv6 unicast route to the BSR, the BSR has an IPv6 unicast route to each C-RP, and
each router on the network has IPv6 unicast routes to the C-RPs.
2.
Use display ipv6 pim bsr-info to verify that the BSR information exists on each router, and then use
display ipv6 pim rp-info to verify that the RP information is correct on each router.
3.
Use display ipv6 pim neighbor to verify that IPv6 PIM neighboring relationship has been correctly
established among the routers.
This manual is related to the following products:
- H3C S9800 Series Switches H3C S5560 Series Switches H3C S5130 Series Switches H3C S5120 Series Switches H3C S12500 Series Switches H3C SR8800 H3C SR6600-X H3C SR6600 H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C WX3000 Series Unified Switches H3C LSWM1WCM10 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module